Thin-bed set with touch thermostat, flexible DN10 sensor protection tube, brass probe sleeve, plastic nails, assembly instructions. The self-adhesive thin-bed heating mat with a connection cable is ready for installation and has been specially developed for installation in levelling compound or flexible adhesive directly below the floor covering. Due to the low installation height of only 3.2mm, it is ideal for the renovation and modernization of bathrooms, showers, kitchens, etc. This floor temperature control system is particularly suitable for retrofitting in angled and/or large rooms, as there is no need to return the second connection. The heating cable with additional protective braiding for the use of the RCD protection circuit is applied to a plastic net. The length of the connecting cables is 4.0 m. Conductor: 1 x 4m, 1.0mm², Voltage: 230 V, Nominal limit temperature: 120°C, Specific heating capacity: 150 W/m², Length load: 11W, Insulation: PVDF / FEP, Resistance tolerance: +10% / -5%, Minimum installation temperature: 5°C, Smallest bending radius: 6 x dA, Calculation width 50 cm, Delivery width: 48 cm, Mat height: 3.2 mm, Protection class: IPX7, Approval: EN 60335-2-96, Area 7.0 m², 0.5 x 14.0 m